Last week I ran into JoAnn Fabrics to buy something and found myself spending an hour in the store after I stumbled across this fabric. I finally decided that I wanted to make some pillows, so I purchased two 18×18 inch pillow form, a half yard of the floral fabric and a basic blue fabric to match, and cord to make the piping edge.
Before cutting the fabric, I made a game plan. For the 18X18 pillow, I planned to cut a 19×19 inch square (in the floral fabric) and then two 19×12 inch rectangles for the back (in the blue fabric). And then for the piping, I calculated I would need it to be 72″ long.
Making the piping edge was actually a lot easier than I thought it would be. I purchased the cheapest craft cord I could find. And for the fabric, I cut a long 2″ wide rectangle. I knew it had to be 72″ long, so with the scraps I had leftover I made two 36″ long rectangles.
I then folded the fabric over the chord, and using my zipper foot, I sewed the chord in place. Back to the fabric of the pillow, I took the the 19×19″ square and used a cup to round off the edges.
I did the same with the blue rectangles, but only on one of the long sides. The other long side I hemmed in place (about 1/2 inch).
Then it is time to assemble it all together. I ending up making two pillows. On the first pillow, I assembled each layer, pinned it down and sewed it all together. The second time, I sewed in parts, and it produced a much better pillow. So with the right (floral) side up, I pinned the piping in place (clean edge facing inwards). And I used the zipped foot again to sew in place.
Then I pinned down the two rectangle pieces, alining them with the rounded corners.
Sew it all together, flip it inside out and insert the pillow form – and you have yourself a pretty adorable throw pillow.